1.5 hp / 110 high Volt Electric Motor DC/ac* 4500 RPM / Light Weight / 1100 Watt

Description

Manta motor Etek type PMG Permanent Magnet Generator MAKE BUILD ELECTRIC CARS VEHICLES PANCAKE ELECTRIC MOTORS etek ELECTRIC ETEC MOTOR CYCLE PMG Permanent Magnet generator PMA wind turbine hydro power wind turbines mills Etek
GREAT FOR RUNNING
SMALL MECHINERY
You are bidding on a 1.5 HP / 110 volt DC / 1100 Watt peak electric motor.
Very powerful for it's size.
Also run them on 110 Volts AC power with the
use of a full wave rectifier
.
SEE -
CLICK HERE
Can also be used as a generator for making Electricity (needs diode) see video below.
Can also be used for powering
electric
karts and bikes.
Can also be used for making Electricity (needs diode)
and changing a battery.
Great for wind or hydro.
Be sure you understand how to set these up for use. LINK HERE!
NOTE:
For wind or hydro power we recommend only our 115 or 208 volt models.
(Use FULL WAVE
RECTIFIER
on the higher voltage models and run them
on AC wall current within their respective voltage groups)
For go karts, mini bikes and cycles we recommend our 12, 24 and 48 volt
models that correspond to your battery bank voltage.
We also sell a 90 volt DC version great for DC water pumps and hydraulic motors
https://youtu.be/PzDN_jmQvzo
Specifications:
Motor length
3.5" diameter / 6" long.
7.5" over all length including shaft
12mm shaft with 1.75 pitch threads with flat slot at shaft tip.
Shaft is 1.5" long
(12mm/1.75 pitch thread by 3/4" long
+ 3/4" flat
)
Two 5/16" extra large mounting holes on the front of the motor.
5/16" NCT mounting holes are 2.874" from center to center (74mm)
4500 rpm  / continuous duty at 75% of peak wattage.
Heavy 12 AWG wire to handle the amps.
A put-up and forget design! Expect decades of dependable service life.
Rain, ice and weather resistant electronics in sealed case (not for under water)
Long life graphite brushes.
We sell replacement brushes and bearings.
Works for both CW or CCW rotations.
Must be mounted in cool place with plenty of
ventilation
. 70% duty cycle.
Epoxy/Lam rotor efficiency = 94.6%
(Brushed motors convert more electricity into usable horsepower)
Weighs ONLY 8.5 lbs.  (Almost 150 Watts Per Pound !)
Can be used as a generator, makes power when turned
(Requires 100 amp blocking diode)
THIS IS NOT A 3/4" Diameter SHAFT, it is 1.5" LONG.
PRODUCT IDEAS
BUILD ELECTRIC CARS / INVENT ELECTRIC BOATS / DESIGN ELECTRIC MOTORCYCLES / MINI BIKES /  GO KARTS / POWERED BICYCLES and WIND TURBINEs
We want you to use these motors in your product designs to help mankind
as we slowly run out of cheap fossil fuels -  Electricity is the future.
HOW TO MAKE A TREAD MILL MOTOR WIND TURBINE
Love these blades you were right, wow can they turn on, im getting up to 40
volts out of my indiana general dv pm motor,there scarey sometimes, im
putting it on youtube for all to see, thanks again
-uptick57
wind generator homemade - YouTube
Video will open in a new window
Using the eBay App? Paste link into a browser window:
[isdntekvideo]
https://youtu.be/WCkpjHPna-Y